rollers
GR7000C GOLF GREENS ROLLER - Operation, Maintenance & Parts Manual
MOUNTING THE SEAT TO THE SEAT FRAME BASE
•
Place the seat down with the seat back oriented toward the rear of the machine (the front of the
machine is the side where the pedals are located).
•
Using the bolts supplied, in seat, align four correct holes of the seat base plate and fix to seat
securing the bolts tightly.
MOUNT THE STEERING JOYSTICK TO THE STEERING SHAFT
•
Select the steering joystick.
•
Slide the joystick into the slot on the top of the steering shaft, already installed in the steering
column directly behind the foot pedal controls, insert the 3/8” bolt into the bottom or lower bolt hole,
select a comfortable operating position, joystick forward for extra operating room or back for less,
once determined insert the other 3/8” bolt into the upper hole & tighten both bolts securely.
ATTACHING THE LEFT-HAND TRAILER ARM TO MACHINE BODY
•
Locate the trailer arm support axle 25mm in diameter (1”) which extends out on the side of the
machine, remove the circlip from the support axle. Oil machined portion. Slide the left hand side
trailer arm, onto the axle, replace the circlip, ensuring it is located in the groove correctly.
ATTACHING DAMPENER STRUT & RH TRAILER ARM
•
Locate the trailer arm support axle 25 mm in diameter (1”) which extends out on the right side of the
machine, remove the circlip from the axle. Hold the right side trailer arm in the vertical position and
slide it part way onto the axle. Locate dampener strut., remove packing from the unattached end.
•
Apply Thread lock “Loctite” to the M10 bolt attached to the dampener strut. Screw the M10 bolt into
the strut support on the trailer arm.
•
If necessary use a soft headed hammer and tap the trailer arm onto the axle until the circlip groove
is revealed, fit the circlip, ensuring it is located in the groove correctly.
