Troy Built Models Arctic Storm 300 SERIES, Operator'S Manual

Page: 24 / 28

24 S
ection
4— P
roduct
c
are
NOTE:
On models equipped with
the LED headlight on top of the auger
housing, make sure to unplug the wire
harness before removing the belt cover
as shown in Figure 4-14.
Figure 4-14
3. Loosen and remove two bolts (a) and
flat washers (b) securing belt guide
(if equipped). Remove belt guide. See
Figure 4-15.
(a)
(a)
(b)
(b)
Figure 4-15
4. Roll auger belt off engine pulley.
See Figure 4-16.
Figure 4-16
5. Carefully pivot the unit up and forward
so that it rests on the auger housing.
6. Remove frame cover from underside of
unit by removing self-tapping screws
which secure it. See Figure 4-4.
7. Loosen and remove shoulder bolt (a) which
acts as a belt keeper. See Figure 4-17.
NOTE: Multi-speed unit shown.
(a)
Figure 4-17
7. Remove belt from around auger pulley,
and slip it between support bracket and
auger pulley. See Figure 4-18.
Figure 4-18
NOTE:
Engaging auger control will ease
removal and reinstallation of belt.
1.
Replace auger belt by following
instructions in reverse order.
NOTE: Make sure to reinstall shoulder
bolt (a) and reconnect spring to frame
after installing a replacement auger belt.
Refer to Figure 4-17.
2. After replacing auger belt, perform
Auger Control test in Assembly & Set-Up
section (page 15).
Auger Belt Replacement (300 Series)
1. Allow the engine to run until it is out of
fuel. Do not attempt to pour fuel from
the engine
2. Remove the safety key to prevent
accidental starting.
3. Remove the self-tapping screw (a)
shown in Figure 4-19, and press the
plastic tabs (b) to release the belt cover
(c). Pull the belt cover (c) up and out from
around the engine and chute assembly.
Set it aside and save.
(a)
(c)
(b)
Figure 4-19
4. Tip the snow thrower up and forward so
that it rests on the auger housing. Remove
the belt keeper (a). See Figure 4-20. Return
the snow thrower to its upright position to
complete the following steps.
(a)
Figure 4-20
5. Slip the front auger belt (a) off of the
engine pulley (b), pushing it forward and
rolling in off of the engine pulley (b). See
Figure 4-21.
(a)
(b)
Figure 4-21
6. Squeeze the auger control bail to release
the auger brake, which is the tab that
holds the belt onto the auger pulley.
Remove the belt.