Troy Built Models Arctic Storm 300 SERIES, Operator'S Manual

Page: 13 / 28

13 S
ection
2 — A
SSembly
& S
et
-U
p
5. Insert flex shaft (b) removed during
Handle Assembly from lower handle into
rear of chute directional control head.
See Figure 2-38. Secure flex shaft to
chute control head with hairpin clip (a)
removed in Step 4.
6. Insert hex end of flex shaft into chute
control rod coupling under dash panel.
See Figure 2-39.
Figure 2-39
7. Ensure speed selector is in fastest
forward speed.
8. Remove cotter pin (a) and washer (b)
from ferrule on end of shift rod.
See Figure 2-40 inset.
(a)
(b)
Shift Rod
Ferrule
Figure 2-40
9. Insert ferrule into top hole of shift
lever and secure with cotter pin (a) and
washer (b) removed in Step 8. Ferrule
may need to be adjusted up or down.
10. Check that all cables are properly routed
through cable guide on top of engine.
See Figure 2-34.
STOP
STOP!
Continue to Set-Up (page
14).
Electric Chute Control
Figure 2-41
1. Remove cotter pin (a), wing nut (b) and
hex screw (c) from chute control head.
Remove clevis pin (d) and bow-tie cotter
pin (e) from chute support bracket.
See Figure 2-42.
(c)
(e)
1 1
2
Chute
Chute
Support
Bracket
Chute Base
(a)
(d)
(b)
Chute
Control Head
Figure 2-42
2. Insert round end of chute control rod
into chute control head. Push rod as
far into chute control head as possible,
keeping holes in rod pointing upward.
See Figure 2-43.
Figure 2-43
3. Place chute onto chute base and ensure
chute control rod is positioned under
handle panel. Secure chute control head
to chute support bracket with
clevis pin (d) and bow-tie cotter pin (e)
removed in Step 1. See Figure 2-44.
(d)
(e)
Figure 2-44
4. Finish securing chute control head by
installing hex screw (c) and wing nut (b)
removed in Step 1. See Figure 2-45.
(c)
(b)
Figure 2-45