![background image](http://html.mh-extra.com/html/troy-bilt/etherbridge/etherbridge_installation-and-user-manual_1172652018.webp)
User’s
Guide
Document #40177-100 Rev. A
15
Safety and Regulatory Notices
FCC Compliance Statement (for United States Users)
This equipment has been tested and found to comply within the limits for
a Class B digital device pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio or television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause interference to radio and television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver,
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The radiated output power of EtherBridge is far below the FCC radio
frequency exposure limits. Nevertheless, the EtherBridge shall be used
in such a manner that the potential for human contact during normal
operation is minimized.
Warning
The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification of this device and may
cause interference levels which exceed the limits established by the FCC
for this equipment. It is the responsibility of the user to obtain and use a
shielded equipment interface cable with this device. If this equipment
has more than one interface connector, do not leave cables connected to
unused interfaces. Changes or modifications not expressly approved by
the manufacturer could void the user’s authority to operate the
equipment.