![background image](http://html.mh-extra.com/html/troy-bilt/etherbridge/etherbridge_installation-and-user-manual_1172652005.webp)
TROY Group, Inc.
2
EtherBridge Adapter Components
Power Connector
– The power supply cable plugs into this
connector.
LED Status Indicators
– used to indicate the operational status of
the EtherBridge adapter. Refer to the table below for detailed LED
status light descriptions.
LAN Port
– used for connecting the EtherBridge adapter to any
10baseT or 100baseTX Ethernet connection (an Ethernet card,
hub, router, or other wired access point) for network access. You
must use the included Ethernet crossover cable (or any other
crossover cable) when you directly connect two devices (such as a
PC, printer, or other Ethernet-enabled device) without the use of a
hub or switch.
Reset Button
– used to restore the EtherBridge adapter to factory
default settings.
Restoring Factory Default Settings
The TROY EtherBridge Adapter can be reset to factory default settings
by performing the following steps:
1. Disconnect power from the EtherBridge Adapter. Press and hold the
reset button for three seconds while reapplying power to the device.
2. Release the reset button as soon as the WLAN LED is blinking and
the LAN LED is off.
3. Press and hold the reset button again for approximately ten seconds.
4. Release the reset button as soon as the WLAN and LAN LEDs begin
flashing rapidly.