EN
13
vaccum cleaner VC 150 E / VC 155 E
4. Remove the coarse dirt from all components and rinse the
collection container (
15
) and the parts of the cyclone
unit (
27
) with cold water. Allow all parts to air-dry. Make
absolutely sure that the HEPA filter (
28
) does not get wet. It
must only be cleaned in a dry condition.
Before start-up, the cyclone unit (
27
) must be re-assembled and
inserted into the collection container (
15
). To do so, please
proceed as follows:
1. Re-assemble the cyclone unit (
27
) by joining the two parts
together again and turning the lower part of the cyclone
unit in the "LOCK" direction.
2. Insert the HEPA filter (
28
) into the dry cyclone unit (
27
).
3. Insert the cyclone unit into the collection container (
15
).
4. Re-attach the collection container (
15
) to the device by
inserting the connecting lug (
29
) of the collection
container (
15
) into the housing recess first and then let the
collection container (
15
) engage in its position.
29
Cleaning the air outlet filters
Check the two air outlet filters regularly (
7
) and remove coarse
dirt and dirt deposits from them.
ü
The device is switched off.
1. Dismount the covers (
30
) from both sides of the two air
outlet filters (
7
) by turning them in counter-clockwise
direction and removing them.
30
30
2. Remove the air outlet filters (
7
) from the covers.
30
7
3. Remove coarse dust and dirt deposits and rinse the air
outlet filters (
7
) with clear water. Observe that the air outlet
filters must dry for 24 hours afterwards.
4. Re-insert the clean and dry air outlet filters (
7
) into the two
covers.
5. Mount the covers (
30
) of the two air outlet filters by
inserting them into the motor housing (
6
) and turning them
in clockwise direction until they engage audibly.
Check the two air outlet filters regularly (
7
) and remove coarse
dirt and dirt deposits from them.
Cleaning the electrical floor nozzle
To make it easier to clean the floor nozzle, the brush roller (
33
)
of the electrical floor nozzle (
10
) can be removed. To do so,
please proceed as follows:
ü
The floor nozzle is not mounted on the vacuum cleaner.
1. On the bottom side of the electrical floor nozzle (
10
) open
the latch (
31
) by slightly pressing on the tongue of the
latch (
32
).
2. Open the latch (
31
) and remove it.
31
32
