EN
11
vaccum cleaner VC 150 E / VC 155 E
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check the charger and charging socket for dirt. Remove
any dirt.
•
Check whether the charger is connected. If the charger is
connected, the device will not start.
The suction capacity is low:
•
Check the device for blockages, large objects can block
the suction nozzles or the collection container. Remove
potential blockages. Watch out for sharp objects, they can
cause injuries.
•
Check the cyclone unit and HEPA filter for dirt. Clean the
cyclone unit and HEPA filter as described in the "Cleaning"
section.
•
Check the brush roller on the floor nozzle, hair and dirt
may have coiled round the brush roller and are blocking it.
Remove and clean the brush roller as described in the
Cleaning chapter.
Info
Wait for at least 10 minutes before switching the
device back on.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug of the charger with wet or
damp hands.
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down completely.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Cleaning
The device should be cleaned before and after each use.
Note
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Keep the connecting terminals on the device and charger
clean.
•
Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.
