5
EN
Operating manual – dehumidifier TTK 95 E
Transport and storage
Transport
Before
transporting the device, proceed as follows:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
To make the device easier to transport, it is fitted with
wheels.
•
Do not use the power cable to drag the device.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
Leave the device to rest for 12 - 24 hours, so the
refrigerant can accumulate within the compressor.
Wait 12 - 24 hours before switching the device back on!
Acting contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Empty and clean the condensation tank prior to storage.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
Device
•
Air filter
•
Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in chapter Technical
Data.
A
B
C
C
D
