EN
8
Operating manual – dehumidifier TTK 95 E
Switching the device on
Once you have completely installed the device as described in
the Start-up chapter, you can switch it on.
1. Press the
power
button (18).
ð
The unit starts to
dehumidify
.
Setting the operating mode
Setting the desired relative room humidity
You can change the desired relative room humidity at any time.
1. Press the
increase value
(11) or
decrease value
button (23)
to set the desired relative room humidity. Setting is possible
in the range between 30 % and 90 % in steps of 5 %.
ð
The desired relative room humidity is shown on the
room
humidity
indication (13) for approx. 5 seconds. Then the
current relative room humidity is displayed again.
Setting the fan speed
You can choose between low and high fan speed (laundry drying
function) at any time.
1. Press the
fan
button (17) to select either low or high fan
speed (laundry drying function).
ð
The selected fan speed is indicated on the
fan speed
indication (15).
Dehumidification
The device keeps running until reaching the desired relative
room humidity. Then the compressor switches off and the fan
keeps running. Once the desired relative room humidity is
exceeded, the compressor switches back on.
The desired relative room humidity can be set within a setting
range from 30 % to 90 % in steps of 5 % at any time.
You can choose between low and high fan speed (laundry drying
function).
Setting the timer
The timer has two modes of operation:
•
automatic switch-on upon expiry of a preset number of
hours.
•
automatic switch-off upon expiry of a preset number of
hours.
The number of hours can be between 1 and 24 and can be
adjusted in increments of 1 h.
Note
Do not leave the operating device unattended in a
freely accessible room with an activated timer.
Automatic switch-on
1. Switch off the device.
2. Press the
timer
button (19).
ð
The number of hours flashes on the
timer
indication (21).
3. Press the
increase value
(11) or
decrease value
button (23)
to set the desired number of hours.
4. Wait for approx. 5 seconds in order to save the setting.
ð
The characters
ON
and the number of hours left until
switch-on appear on the
timer
indication (21).
ð
The timer setting equals the desired number of hours.
ð
The device starts after the set time has passed.
Note regarding automatic switch-on:
•
Pressing the
power
button (18) deactivates the automatic
switch-on function.
Automatic switch-off
ü
The device is switched on.
1. Press the
timer
button (19).
ð
The number of hours flashes on the
timer
indication (21).
2. Press the
increase value
(11) or
decrease value
button (23)
to set the desired number of hours.
3. Wait for approx. 5 seconds in order to save the setting.
ð
The characters
OFF
and the number of hours left until
switch-off appear on the
timer
indication (21).
ð
The timer setting equals the desired number of hours.
ð
The device switches off after the set period of time.
Auto stop function
If the water tank is full, not inserted correctly or the desired
relative room humidity has been reached, the device will stop
automatically.
Swing function
Using the swing function, you can activate continuous
movement of the ventilation flap. This enables an even
distribution of the air current in the room.
1. Press the
swing function
button (10).
ð
The ventilation flap moves up and down continuously.
2. Press the
swing function
button (10) again to deactivate the
swing function. The ventilation flap opens completely.