8
EN
dehumidifier TTK 175 S / TTK 355 S
While
transporting the device, observe the following:
•
Hold the transport handle in both hands and tilt the device
so that it can be rolled on its wheels.
•
Move the device to the site where you want to use it.
Stacking
After
transporting the device, proceed as follows:
•
Set up the device in an upright position after transport.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Drain any possibly remaining condensate.
When the device is not being used, observe the following
storage conditions:
•
Only store the device in a room measuring more than 4 m
2
.
•
Only position the device in rooms where there is no source
of ignition (e.g. open flames, an active gas appliance or an
electric heater).
•
Store the device in a dry location and protected from frost
and heat.
•
Store the device in an upright position where it is protected
from dust and direct sunlight.
•
If required, use a cover to protect the device from invasive
dust.
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and start-up
Scope of delivery
•
1 x device
•
1 x air filter
•
1 x Condensation drain hose, 19 mm diameter
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
