6
EN
dehumidifier TTK 100 E
Device depiction
1
6
7
2
5
4
3
No.
Designation
1
Air outlet
2
Transport handle
3
Condensation drain hose connection
4
Wheels
5
Air inlet with air filter
6
Condensation tank
7
Control panel
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Please note that additional transport regulations might apply to
devices containing flammable refrigerants. The equipment's
arrangement and the maximum number of components to be
transported together can be gathered from the applicable
transport regulations.
To make the device easier to transport, it is fitted with a carry
handle.
To make the device easier to transport, it is fitted with wheels.
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Do not use the power cable to drag the device.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, proceed as follows:
•
Set up the device in an upright position after transport.
•
Leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 to 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
Storage
Before
storing the device, observe the following:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
Only store the device in a room measuring more than 4 m
2
.
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
