6
EN
oil-filled radiator TRH 28 E
Assembly and start-up
Scope of delivery
•
1 x Oil-filled radiator
•
2 x Foot with 2 castors each
•
1 x Cable holder
•
1 x Screw
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Mounting the feet
The castors on the feet are already preassembled.
1. Place the device upside down on a scratch-proof, even
surface and in a stable position.
2. Place the left foot upside down on the left side of the
device.
3. Fasten the left foot with a screw.
4. Place the right foot with the slots upside down on the last
two fins on the right side of the device.
5. Close the four clips of the right foot.
6. Turn the device over and set it down on the castors.
ð
Check the feet and castors for tight fit. The feet should
rest evenly on the fins to ensure the upright position of
the device.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
•
Before starting the device, check the condition of the
power cable. If there are doubts as to their sound
condition, contact the customer service.
•
The device may only be operated when fully assembled
and set up in a vertical position on a stable surface.
Operation on instable ground is prohibited.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Do not position the device directly below a wall socket.
•
Make sure that the device cannot come into contact with
moisture or water.
