5
EN
Operating manual – infrared heating panel TIH 300 S / TIH 400 S / TIH 500 S / TIH 700 S / TIH 900 S / TIH 1100 S
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, proceed as follows:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
Storage
Before storing the device, proceed as follows:
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
protected from dust and direct sunlight
•
with a cover to protect it from invasive dust if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x IR heating panel
•
4 x Screw
•
4 x Dowel
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Mounting on a wall
When mounting the device to a wall, observe the minimum
distances from walls and other objects as specified in the
Technical data chapter.
•
Do not install the device directly behind a door.
•
Never install the device in a way that it radiates directly
onto walls or other objects.
•
Only install the device in a horizontal position.
1. Spread out a suitable template over the back of the device
and mark the positions for the bore holes.
2. Attach the template to the wall using adhesive tape or
similar.
3. Drill the holes into the wall at the positions marked on the
template.
4. Remove the template from the wall.
