4
Operating Manual – Electric Heaters TEH 200 / TEH 300 / TEH 400 Version 3.0
EN
• Remove all packing materials which serve to protect the
device during transport.
• Should the electric heater be damaged, please contact the
responsible dealer or manufacturer, where the purchase was
made.
• The electric heater may only be lifted at the points provided
with lifting gear (forklift pockets (6), transport lugs (2))
intended for handling. The carrying capacity of the lifting gear
must be suitable for the weight of the electric heater (see
Technical data).
• For simple transport to the respective operating site the
devices are further equipped with partially steerable rollers.
– Only wheel the device on firm, level ground.
The following should be observed
before
transporting the device
using the
rollers
:
Caution!
Trip hazard! Make sure that nobody is situated in the
immediate proximity.
The following should be observed
before
transporting the device
using
lifting gear
:
Danger!
Risk of injury from suspended loads. Make sure that
nobody is situated in the immediate proximity.
• Only instructed persons are allowed to perform the transport
by use of lifting gear.
• Consider the centre of gravity when transporting the load.
The following should be observed
after
transporting the device:
• Lock the swivel castors (5)!
Storage
• Store the cleaned device in a dry location and protect it
against dust.
• Before restarting the device, check the condition of the power
cable. If there are doubts as to the sound condition, contact
the customer service.
• Have the device checked once a year by an electrically skilled
person at any rate.
The device can be stacked for storage purposes. In doing so,
observe the following:
• Only use suitable lifting gear.
• Make sure that the rollers of the device at the bottom are
locked and the device cannot move. To protect the rollers and
the frame, the bottommost device is to be jacked up as
illustrated below.
Caution!
To prevent damage to the device, the bottom strut
should not be allowed to rest on the support. A
minimum distance of 5 mm to the bottom must be
observed!
• Make sure that the wheels of the device to be stacked are
pointing inwards as is indicated in the following figure.
• The maximum amount of devices to be stacked on top of one
another is 3 (for transportation in a truck: max. 2 devices).
• Place the device at the bottom on firm, level ground.
Transport and storage
2
5
5
6
7
min. 5 mm
