EN
7
LED construction site spotlight PWLS 10-150
Operation
Tips and notes on handling the LED construction site
spotlight
General information:
•
Avoid looking directly into the light source.
•
Use the devices only for a temporary illumination of indoor
and outdoor areas, e.g. for construction sites.
•
The LED construction site spotlights are particularly suited
for illuminating larger areas.
Warning of hot surface
Some parts of this product can become very hot and
cause burns. Particular attention has to be given where
children and vulnerable people are present!
Warning
Do not look directly into the LEDs! The optical radiation
can be harmful for your eyes.
Warning of electrical voltage
Do not touch the device's power cable or power cable
connection with wet or damp hands.
Note
Make sure that the power cable is guided along the
back of the device. Never guide the power cable along
the front of the device!
Note
Do not connect the device at ambient temperatures
below -25 °C or above 55 °C, otherwise it will be
damaged!
Switching the device on
Please proceed as follows to switch the device on:
1. Check whether the power cable is plugged in correctly.
2. Set the on/off switch (7) to position
I
for the low brightness
level or to position
II
for the high brightness level.
ð
The device switches on and the surface LED (2) lights
up.
7
Shutdown
•
Switch the device off by setting the on/off switch (7) to
position
O
.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation
Article number
Cable drum
7.333.000.370
High-quality extension cable 15 m 7.333.000.372
High-quality extension cable 20 m 7.333.000.376
High-quality extension cable 25 m 7.333.000.369
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
The device is not lit:
•
Check whether the power cable is connected correctly.
•
Check the power cable and mains plug for damage. If you
notice damages, do not try to take the device back into
operation.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
The LEDs are defective. They cannot be replaced. Contact
the Trotec customer service.