background image

EN

3

LED construction site spotlight PWLS 10-150

Do not use the device in potentially explosive rooms or
areas and do not install it there.

Do not use the device with wet or damp hands.

Do not use this device near bathtubs, shower trays,
swimming pools or other water containers. Risk of electric
shock!

Do not expose the device to directly squirting water.

Let the device dry out after a wet clean. Do not operate it
when wet.

Do not under any circumstances use the device if you
detect damages on the mains plug or power cable. 
If the power cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Defective power cables pose a serious health risk!

Do not sit on the device.

Switch the device off and disconnect the power cable from
the mains socket when the device is not in use.

Before carrying out maintenance, care or repair work on
the device, remove the mains plug from the mains socket.
Hold onto the mains plug while doing so.

The electrical connection must correspond to the
specifications in chapter Technical data.

Check accessories and connection parts for possible
damage prior to every use of the device. Do not use any
defective devices or device parts.

Do not look directly into the LEDs! The optical radiation can
be harmful for your eyes.

The LEDs and other parts of the device can become very
hot. Do not touch any hot surfaces of the device.

Intended use

Use the device according to the technical data and only for a
temporary illumination of indoor and outdoor areas, e.g. for
construction sites.

Foreseeable misuse

The device is not intended for permanent illumination of indoor
and outdoor areas.
Any other use than the one described in the chapter "Intended
use" is regarded as reasonably foreseeable misuse.

Personnel qualifications

People who use this device must:

have read and understood the operating manual, especially
the Safety chapter.

Residual risks

Warning of electrical voltage

Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!

Warning of electrical voltage

Work on the electrical components must only be
carried out by an authorised specialist company!

Warning of electrical voltage

There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.

Warning of hot surface

Some parts of this product can become very hot and
cause burns. Particular attention has to be given where
children and vulnerable people are present!

Warning

Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!

Warning

The device is not a toy and does not belong in the
hands of children.

Warning

Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.

Caution

Keep a sufficient distance from heat sources.

Warning

Do not look directly into the LEDs! The optical radiation
can be harmful for your eyes.

Note

If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.

Summary of Contents for PWLS 10-150










Reviews: