5
EN
Operating manual – cordless drill driver PSCS 10-12V
•
The charger is only suited for indoor use.
•
Keep the charger clean. Contamination entails a risk of
electric shock.
•
Do not operate the charger on highly combustible ground
(e.g. paper, textiles etc.) or in an inflammable environment.
The heat generated by the charger during charging entails
a risk of fire.
•
Only use the charger for charging the battery. The charger
must not be used as power supply for the power tool.
Device-specific safety warnings for cordless drill
drivers
Wear eye and mouth protection when processing
materials that may contain harmful substances (e.g.
asbestos).
•
Secure the workpiece with tensioning devices or a vice.
•
Hold the power tool firmly. When tightening or loosening
screws, high reaction torques can occur temporarily.
•
Immediately switch off the power tool if the insertion tool
blocks. Beware of high reaction torques causing a
kickback.
•
Hold power tool by insulated gripping surfaces when
performing an operation where the cutting accessory
may contact hidden wiring.
Cutting accessory contacting
a "live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
•
For any work on the device, as well as during transport or
storage, set the switch for the rotational direction to centre
position (locked). This prevents unintentional starting of the
power tool.
Residual risks
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket and the battery from the device!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning of explosive substances
Do not expose the battery to temperatures above 45
°C! Do not let the battery come into contact with water
or fire! Avoid direct sunlight and moisture. There is a
risk of explosion!
Warning!
Toxic dusts!
The harmful / toxic dusts produced during operation
pose of risk to the health of the operator and persons
in the vicinity.
Wear eye protection and a protective mask!
Warning!
Do not process materials containing asbestos.
Asbestos is considered carcinogenic.
Warning!
Make sure not to hit power, gas or water lines when
working with a power tool.
If necessary, use a pipe detector to check the wall you
want to drill in or slit open.
Warning!
Risk of injuries caused by flying parts or bursting tool
heads.
Warning!
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
