EN
15
routing machine PRTS 10-1200
5. Guide the device through the workpiece with even
pressure.
I.
II.
4
6. To complete the milling process, release the locking lever
for the milling depth lock (
4
) by turning it upwards.
7. Allow the routing machine to return to the uppermost
position.
8. Switch the device off.
Progressive milling
For greater milling depths, it is possible to perform stepwise
milling by means of the step buffer (
9
).
1. Turn the step buffer (
9
) until it audibly engages at the
highest step below the depth stop.
9
2. Set all further milling depths using the lower steps of the
step buffer (
9
).
Edge and profile milling
Info
The milling cutter must be equipped with a guide pin or
a ball bearing when performing edge or profile milling
operations without using a rip fence.
•
Use clamps or another practical way to secure and
support the workpiece to a stable platform.
Holding the
workpiece by your hand or against the body leaves it
unstable and may lead to loss of control.
Note
Excessive pressure when performing edge or profile
milling operations can damage the edge of the
workpiece.
1. Move the activated device towards the workpiece from the
side until the ball bearing rests on the edge of the
workpiece to be machined.
2. Guide the device along the edge of the workpiece with
both hands. Make sure to use a suitable, rectangular
support.
