13
EN
Operating manual – cordless pendulum action jigsaw PJSS 11-20V
Mounting / removing the sliding block
To protect the surface of the material to be processed, the
sliding block is already preassembled. You may remove the
sliding block if required.
1. Remove the battery (19) from the device (see Removing
the battery).
2. Release the two fastening clips (24) at the rear.
3. Slowly push the sliding block (25) forward while carefully
detaching the front part of the sliding block from the base
plate (6).
4. Pull the sliding block (25) downwards carefully.
24
25
6
5. To reattach the sliding block (25), first push it onto the
front part of the base plate (6).
6. Then let the fastening clips (24) lock in place at the rear.
7. Check the sliding block (25) for tight fit.
8. Refit the battery (19; see Insert the battery).
Mounting / removing the anti-splinter guard
The anti-splinter guard serves to avoid tearing of the surface
when sawing in wood. The anti-splinter guard can only be used
in combination with certain types of saw blades and at a cutting
angle of 0°. You may remove it if required, e.g. if you want to
make a mitre cut.
The anti-splinter guard is already preassembled.
1. Remove the battery (19) from the device (see Removing
the battery).
2. First remove the sliding block (see Mounting / removing
the sliding block).
3. Remove the anti-splinter guard (11) from the base plate (6)
by carefully pushing the anti-splinter guard outwards.
6
11
25
4. To reinsert the anti-splinter guard (11), carefully push it
into the recess of the base plate from below until the anti-
splinter guard locks in place. When doing so, make sure
that the smooth side of the anti-splinter guard points away
from the device.
5. Refit the battery (19; see Insert the battery).
