EN
13
bench grinding machine PBGS 10-120
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
•
Check the contents for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.
Table assembly (optional)
Note
The screws and nuts required for the assembly are not
included in the scope of delivery.
1. Position the device on a suitable base (e.g. table or
workbench).
2. Mark the holes on the device base through the 4 holes for
table assembly.
3. Remove the device and drill the holes into the base.
4. Insert the screws into the 4 holes for table assembly on the
device base.
5. Screw the device to the base (e.g. table or workbench)
using 4 screws and nuts.
Assembly of the workpiece supports
Note
Assembly of the workpiece supports (
33
) must be
carried out ensuring that the distance between the
sanding or polishing disc and the two workpiece
supports (
33
) is as small as possible. The distance may
amount to maximally 2 mm. Make sure that the
workpiece supports (
33
) do not touch the sanding or
polishing disc. Adjust the distance of the workpiece
supports (
33
) to the sanding or polishing discs at
regular intervals, in order to balance out wear and tear
of the sanding or polishing discs.
The workpiece support (
33
) is not pre-assembled in the as-
delivered condition and has to be mounted on the device prior to
initial start-up.
1. Insert the nut (
22
) into the matching recess on the
mounting flange (
39
) of the workpiece support and hold it
in place with your finger.
2. Push the knurled screw (
32
) through the groove of the
workpiece support (
33
) and screw both items together
using the nut (
22
) on the mounting flange (
39
).
3. Adjust the workpiece support (
33
) so that the distance to
the sanding or polishing disc is less than 2 mm. In doing
this, observe that the angle is always greater than 85°.
4. Repeat this assembly process on the other side of the
device.
32
22
39
33
