12
EN
bench grinding machine PBGS 10-120
Technical data
Parameter
Value
Model
PBGS 10-120
Nominal voltage
230 V / 50 Hz
Power consumption
120 W
Nominal idle speed n
0
0 - 11,500 rpm
Operating speed
45 m/s
Weight
2 kg
Sanding disc diameter
75 mm
Hole diameter of the sanding disc
10 mm
Sanding disc thickness
20 mm
Sanding disc hardness grade
M
Cable length
2 m
Protection class
II (double insulation) /
Type of protection
IPX0
Sound values in accordance with EN 62841-1
Sound pressure level L
pA
86 dB (A)
Sound power L
WA
99 dB(A)
Uncertainty K
3 dB
Wear hearing protection.
Excessive noise can lead to hearing loss.
Notes relating to noise information:
•
The
noise emission values
specified were measured by
means of a test procedure standardised in EN 62841 and
can be consulted for the comparison of one power tool
with another.
•
The
noise emission values
specified can also be used for
preliminary load assessment.
•
The actual
noise emission
may differ from the stated
values during operation of the power tool. This depends on
how the power tool is used and especially on the type of
workpiece being processed. Try to keep the load caused
by noise emission at a minimum level. All parts of an
operating cycle must be taken into consideration for this
(e.g. times at which the power tool is switched off and
times when it is switched on but runs without load).
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Disassemble the flexible shaft.
•
Allow the device to cool down.
•
When transporting the table sander, lift it at the housing or
at the two protective covers.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Disassemble the flexible shaft.
•
Allow the device to cool down.
•
Clean the device as described in the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
Ambient temperature below 45 °C
•
Protected from dust and direct sunlight
•
Store the insert tools and other accessories in the storage
box.
