EN
7
radiant heater IR 2001
2. The screws for fixing the wall holder and the device are
pre-installed. Loosen the four screws from the device and
screw the wall holder to the device as indicated.
ð
The wall bracket can be rotated to both sides
between 30° and 45°.
Installation
When installing the device, observe the minimum distances
from walls and other objects as described in the Technical data
chapter.
•
Do not install the device directly behind a door.
•
Never install the device in a way that it radiates directly
onto walls or other objects. Observe the minimum
distances from walls or other objects according to the
Technical data chapter.
•
Only install the device in a horizontal position.
•
Please note that the minimum distance to the front also
applies to objects mounted on the ceiling, e.g. fans, lamps
or sprinkler systems.
C
A
B
C
The following is required for installation:
•
a pencil for marking the drill holes
•
a tape measure for determining the distances
•
a suitable drill
•
a drill suitable for the wall/ceiling material, Ø 6 mm.
•
a wrench SW 10 mm
•
a spirit level
1. Mark the drill holes on the wall/ceiling:
ð
Please note that the device must be mounted in
horizontal position. Use a spirit level for this purpose.
2. Drill the holes into the wall/ceiling at the marked positions.
3. Insert the wedge bolts included in the scope of delivery
into the holes without the nuts and washers.
