EN
7
radiant heater IR 2010 / IR 3010
IR 2010
1. Mark the drill holes on the wall.
2. Drill the holes into the wall at the marked positions.
3. Insert suitable wall plugs into the drill holes.
4. Screw the mounting bracket to the wall.
5. Check the mounting bracket for tight fit.
6. Screw the device onto the mounting bracket. To do so,
fasten the wall holder to the mounting bracket using the
fastening screws and wing nuts.
7. Make sure that the device is attached securely.
8. Tilt the device to the desired angle. The device can be
tilted upwards and downwards by 90°.
Use the Allen wrench to fix the inclination angle.
90°
IR 3010
1. Mark the drill holes on the wall.
2. Drill the holes into the wall at the marked positions.
3. Insert suitable wall plugs into the drill holes.
4. Screw the mounting brackets to the wall.
5. Check the mounting brackets for tight fit.
6. Screw the device onto the mounting brackets. To do so,
fasten the wall holders to the mounting brackets using the
fastening screws and wing nuts.
