EN
7
radiant heater IR 2000 C / IRS 2010
Assembly and start-up
Scope of delivery
IR 2000 C
•
1 x Device
•
2 x Fastening chain
•
2 x Carabiner hooks
•
1 x Remote control
•
1 x Manual
IRS 2010
•
1 x Device
•
3 x Fixation plate
•
3 x Wedge bolt
•
4 x Fastening nut
•
2 x Screw
•
1 x Foot
•
3 x Telescopic rod
•
1 x Remote control
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning of electrical voltage
Risk of injury due to incorrect assembly!
Local or national regulations may apply for installation.
We recommend to have the installation carried out by a
qualified electrician.
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Warning
The device must not be placed directly below a socket,
as the electrical cables may be hit when the device is
being mounted. This may cause an electric shock.
Observe the minimum distances for mounting the
device (see chapter Technical data).
Assembly of the IR 2000 C
ü
Use tools suitable for the intended task.
ü
Two suitable ceiling holders are preassembled.
1. Attach one carabiner hook to each end of a fastening
chain.
2. Hook both carabiner hooks with the fastening chains into
the provided holes on top of the device.
3. Close the carabiner hooks and check whether the
fastening chains are firmly connected to the carabiner
hooks.
4. Hook the fastening chains into the ceiling holder.
