5
EN
Operating manual – oil heater IDX 30 D
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, proceed as follows:
•
Switch off the device.
•
Wait until the device has cooled down completely.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
While
transporting the device, observe the following:
•
Slightly lift the device by the transport handle (2) until the
rear support no longer touches the ground.
•
Wheel the device to the desired position.
Storage
Before
storing the device, proceed as follows:
•
Switch off the device.
•
Wait until the device has cooled down completely.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
Assembly and installation
Scope of delivery
•
1 device
•
1 transport handle
•
2 wheels
•
2 wheel caps
•
1 axle
•
2 locking rings
•
1 frame
•
4 small screws
•
4 large screws
•
1 manual
Assembly
Upon delivery the device is already partially preassembled. The
wheels, transport handle and frame still need to be mounted.
Assembling the wheels
Prior to initial start-up, the wheels and the axle must be
attached to the frame. To do so, please proceed as follows:
1. Slide the axle through the openings at the frame.
2. Attach both wheels to the axle.
3. Attach the locking rings to the axle.
4. Fasten the wheel caps to the wheels.
Info
If necessary, the frame can be disassembled again
(e.g. for storage). To remove the wheels from the axle,
you can carefully loosen the wheel caps and locking
rings by means of a slotted screwdriver.
