EN
10
Operating manual – oil heater IDX 30 D
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down completely.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Cleaning the housing
Clean the device with a soft, damp and lint-free cloth. Ensure
that no moisture enters the housing. Protect electrical
components from moisture. Do not use any aggressive cleaning
agents such as cleaning sprays, solvents, alcohol-based or
abrasive cleaners to dampen the cloth.
Filling the tank
The fuel tank cap and the filling level indication are located to
the left of the control panel.
ü
Before attempting to fill the tank, wait until the device has
cooled down completely.
ü
Only use fuel suitable for the device (see technical data).
1. Position the device on firm, level and incombustible ground.
2. Unscrew the fuel tank cap (9).
IDX 30 D
THERMOST
AT CONTROL
ROOM TEMP
.
CLOSE
OPEN
CLOSE
OPEN
9
11
3. Fill the tank. In doing so, observe the filling level
indication (11). Stop filling the tank just before the red
range.
4. Screw the fuel tank cap (9) back onto the tank. Observe the
recesses at the tank opening and the protrusions at the fuel
tank cap. They must be aligned when attaching the fuel
tank cap. Make sure that the fuel tank cap is firmly attached
to avoid leakage.
IDX 30 D
THERMOSTAT CONTROL
ROOM TEMP.
