14
EN
digital true RMS multimeter BE52
3. Start the Trotec MultiMeasure Mobile app on the terminal
device.
ð
A list of active and available sensors will be displayed.
4. Press the button to refresh the display if the desired
measuring device is not displayed as an active measuring
device.
ð
The terminal device now searches all active sensors
again and shows them on the display.
Sensors
Sensors
Measurements
Reports
Customers
Settings
Active sensors nearby
Available sensors
Connect
5. Select the desired sensor from the list of active sensors.
ð
The measuring device and the terminal device establish
a connection with each other.
ð
The measured value indication appears on the display.
Measured value indication
When the sensor and the terminal device have established a
successful connection, the submenu for the measurement will
open and the display indicates the measuring mode set at the
multimeter in a continuous measurement.
You can switch to a different measuring mode by setting the
rotary switch at the multimeter to the desired measuring mode.
For some measuring modes you additionally have to press the
MODE
button (see Operation chapter).
As an example, the screen for the AC voltage measuring mode
is shown here:
Sensors
Measurements
Reports
Customers
Settings
AC voltage
HOLD
REL
MIN
MAX
PEAK
The last 12 values measured over time and the corresponding
unit are displayed in the measured value field.
After several measurements have been carried out, the lowest
value, highest value, average value and current value are
displayed below the measured value field.
Measuring menu
Press the button or the free area below the measurement
value display to open the measuring menu at the bottom of the
display. You can select from the following options in the
measuring menu:
•
reset the min/max average value
•
switch over between X/T measurement (coordinate
system) and the display of individual values
•
terminate the connection to the sensor
•
view and modify sensor settings
•
start recording of measured values
X/T measurement
Disconnect sensor
Sensor settings
Start recording
Sensors
Measurements
Reports
Customers
Settings
HOLD
REL
MIN
MAX
PEAK
Reset min / max / Ø
AC voltage
