EN
7
vane anemometer controlled via smartphone BA16WP
Continuous measurement
Info
Note that moving from a cold area to a warm area can
lead to condensation forming on the device's circuit
board. This physical and unavoidable effect can falsify
the measurement. In this case, the app will either
display incorrect measured values or none at all. Wait a
few minutes until the device has become adjusted to
the changed conditions before carrying out a
measurement.
When the appSensor has been successfully connected to the
terminal device, a continuous measurement is started and
indicated. The refresh rate is 1 second. The 12 most recently
measured values are displayed graphically (9) in chronological
sequence. The currently determined and calculated measured
values are displayed numerically (10).
Sensors
MEASUREMEN
TS
Reports
CUSTOMERS
SETTINGS
Temperatur
e
Relative humidity
[24,7 | 25,4] Ø 25
[37,6 | 58] Ø 40
25,3 °C
37,6 % RH
°C
% RH
% RH
°C
9
10
25
26
27
28
40
35
11
Air velocity
0,43 m/s
Volumetric flow
0,0345 m³/min
BA16WP
m/s
[0,42 | 0,44] Ø 0,43
No. Designation
Meaning
9
Relative humidity
indication as
graphic display
Indicates the relative humidity as
measured over the course of time.
Temperature
indication as
graphic display
Indicates the temperature as
measured over the course of time.
Volumetric flow
indication as
graphic display
Indicates the volumetric flow as
calculated over the course of time
(after having entered the area).
No. Designation
Meaning
10 Tabular
value
display
Temperature:
Indicates minimum,
maximum and average value as well
as the current value.
Relative humidity:
Indicates
minimum, maximum and average
value as well as the current value.
Air velocity:
Indicates minimum,
maximum and average value as well
as the current value.
Enter area / volumetric flow:
Tap on
the field an enter the cross-sectional
area. Then the calculated value for the
volumetric flow will be displayed.
11
Menu
button
Opens the menu to adjust the settings
of the current measurement.
Info
The indicated measured values will not be saved
automatically.
Info
By tapping on the graphic display (9) you can switch
over to the numeric display and vice versa.
Info
The volumetric flow can only be approximated, since
the flow type and speed of the air current is not
homogenous and thus identical across the entire
cross-section of the line / pipe but varies from the
centre to the periphery! For a preferably precise
measurement move the sensor slowly and evenly in a
spiral motion from the centre to the edge and use the
determined average value as result.
