6
EN
humidifier B 5 E
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Water softener
•
1 x Brush
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only put up the device in an upright, stable position on firm
ground.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are unrolled completely.
•
Make sure that there are no moisture-sensitive objects
located in the immediate vicinity of the mist nozzle, since
water may condense near the mist nozzle.
Filling the water tank
The water tank should be filled before first use or when the
empty water tank indication (21) lights up.
Note
Fill the device with fresh drinking water only. The
water temperature must not exceed 40 °C.
Scented oil or other additives can damage the plastics
and the nebulizer membrane.
Info
If possible, change the water every 3 days to prevent
bacterial growth.
1. Remove the water tank (2) from the device by lifting the
water tank at the transport handle (1).
Note that there may still be residual water left in the lower
part (3) if the device was used beforehand.
2
3
1
2. Remove the mist nozzle (14) from the water tank to
prevent the mist nozzle from falling out when the water
tank is turned over.
14
3. Turn the water tank over.
