8017 Trotec Speedy
300 fiber
OPERATION
28/07/2015
Trotec Produktions- und Vertriebs GmbH
_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
40 / 54
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
the object with the focus tool. If the object slopes too much in the area to be
engraved, the rotary attachment can be tilted, so that the surface of the object is
running again parallel with the X axis of the motion system. To do this, lift the right-
hand side of the rotary attachment and place a wedge under it. Take care not to lift
the rotary attachment too high, as it can touch the lens holder.
Processing:
Also consult the Software Manual for further information.
9.
Generate a graphic with the help of your graphics software. The size is not
important, as the graphic can be adjusted to the dimensions of the work piece by
the printer driver.
10.
Then perform the settings for size and orientation in the JobControl under "Plate,
Setup Plate" and, if necessary, select the material. Please note especially, that you
can determine the orientation of the graphic on the object with "Job
Orientation”.
11.
In the "Options" menu of the JobControl select "Rotary Engraving Attachment" and
enter the diameter of the object.
12.
Double-click on the previously generated job in the waiting list to place it on the
plate.
13.
Use the mouse to drag the job to the position of the plate, at which the desired
engraving area is located on the object. Use the rulers in the machine and in
JobControl for orientation and move the lens holder directly over the desired
position, after you have connected the computer with the laser, and position the job
on the screen according to the position of the lens.
14.
Establish the connection to the laser.
15.
Switch on the exhaust system (only necessary if you do not use an original Trotec
exhaust system).
16.
Activate the START button in the Engraver Control of the JobControl and start the
engraving process.
