8017 Trotec Speedy
300 fiber
OPERATION
28/07/2015
Trotec Produktions- und Vertriebs GmbH
_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
36 / 54
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
4.
Generate a graphic with the help of your graphics software. The size of the graphic
does not matter as the printer driver adjusts it to the work piece automatically if
requested.
Also consult the Software Manual for further information.
5.
Select "File Print", to access the printer driver, where you can perform work piece
and material settings as well as specify a job name or a job number.
This file is automatically transferred into Trotec JobControl.
6.
After the material, the working direction, the orientation of the work piece and the
orientation of the plate have been specified in the Trotec JobControl under "Plate,
Setup Plate", the job can be positioned on the plate with a double-click. If necessary,
the job can be positioned at any position on the plate by dragging with the mouse.
The position of the job corresponds with the position on the working table.
Make sure that on processing flammable materials the air assist is on!
7.
Establish a connection with the laser system by clicking on the button "Establish
Connection" in JobControl.
8.
Switch on the exhaust system. When using an original Trotec exhaust system with
installed connection cable, this happens automatically
– check only, whether in the
indicator "Exhaust Ready" is green in the Engraver Control of the JobControl.
9.
Finally press the START button (green arrow) in the Control of the JobControl, to
start the process.
10. While the laser is working, you can generate the next graphic.
11. When the job is complete, the JobControl offers you the following possibilities:
- delete the job
- Job Reset and placing back in to the waiting list for later repeat.
- Job Reset and immediate repeat
