EN
7
oil heater IDE 20 / IDE 30 / IDE 50 / IDE 60 / IDE 80
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with wheels.
To make the device easier to transport, it is fitted with a carry
handle.
To make the device easier to transport, it is fitted with a
transport handle and wheels.
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
•
Before transporting or moving the device, make sure that
the tank cap is tightly closed.
While
transporting the device, observe the following:
•
Slightly lift the device by the transport handle until the rear
support no longer touches the ground.
•
Wheel the device to the desired position.
Storage
Before
storing the device, proceed as follows:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
Store the device in a dry location and protected from frost
and heat.
•
Store the device in an upright position where it is protected
from dust and direct sunlight.
•
If required, use a cover to protect the device from invasive
dust.
Assembly and start-up
Scope of delivery
•
1 x Oil heater
•
1 x Frame components
•
2 x Wheel
•
1 x Axle
•
1 x Carry handle
•
1 x Installation material
•
1 x Flue pipe connection
•
1 x Cable holder (IDE 30, IDE 50, IDE 60, IDE 80)
•
1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Upon delivery the devices are already partially preassembled.
The wheels, axle and frame still need to be mounted.
The assembly procedure is described below using the device
IDE 20 as example.
Assembling the wheels
Prior to initial start-up, the wheels and the axle must be
attached to the frame. To do so, please proceed as follows:
1. Slide the axle through the openings at the frame.
2. Attach both wheels to the axle.
3. Attach the locking rings to the axle.
