EN
7
oxygen regenerator Zerozon 200
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only put up the device in an upright, stable position on firm
ground.
•
Make sure the device is only placed on firm, dry and
vibration-free ground.
•
Position the device as close as possible to the centre of the
room to ensure an optimum air circulation.
•
When positioning the device, keep a sufficient distance to
heat sources.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Do not position the device near inflammable substances
and gases.
•
Make sure that the air inlet and outlet are not obstructed.
•
Make sure that the device is protected from spray water.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
The room temperature should be approx. 5 °C higher than
the usual room temperature.
Installation of the device in the room, the air of which is to
be purified
•
When positioning the device, make sure it is located in the
centre of the room in which the oxygen regeneration is to
be performed.
•
Prior to operation you have to ensure that the filters have
been correctly installed in the device.
•
The device works in recirculation mode, this means that
the air enters the device via the air inlet opening and is
blown out through the air outlet opening.
Air circulation in sealed off area via air circulation:
Setting up the device in combination with an ozone
generator (Airozon Professional series) as a master-slave
solution
The device can be used independently or in combination with an
ozone generator (e.g. Airozon 20000).
Connect the ozone generator to the mains socket of the
separate connection (
10
).
The stacking aid (
1
) allows a suitable ozone generator
(e.g. Trotec Airozon 20000) to be stacked directly on
the
Zerozon 200
.
Connecting the power cable
•
Insert the mains plug of the
Zerozon 200
into a properly
secured mains socket located outside of the room to be
cleaned. This enables you to switch the device off in case
of an emergency without having to access the room.
