9
.
Resetting process
Make sure to turn off power at breaker box.
OF
F
OF
FO
FF
OFF
Turn on power at breaker box and #1 Fan is ready for setting.
OFF
OFF
OFF
ON
Before starting the remote control setting process, lower the canopy of #2 Fan and disconnect the Black wire.
Put the wire nut on the black wire from the house
*See the remote control setting process
9-5 to set up #1 Fan.
#1 Fan
is ready for setting.
Outlet Box
#1 Fan
(Disconnecting)
Canopy
Mounting Bracket
Outlet Box
#2 Fan
Fan need to have “resetting process” for the following issues .
1. Missing or replacing the transmitter.
2. Missing or replacing the receiver.
3. Muti-fans at the same power line.
(In event, one or two fans out of three need to do the resetting in above situation.)
P8
1. Switch off the main power and make sure fan has completely stopped .
2. Installing the New receiver or New transmitter before process resetting.
3. Switch on the power again, and immediately.
This process must be done within 20 seconds after switching on the power.
This fan has completed the settings successfully and the fan is ready for operation!
Press and hold the Fan On/Off button
for
8 seconds until the Receiver “Long Beeps”.
OF
F
OF
FO
FF
OFF
For single fan
In the event the fan does not operate properly, please check the following steps.
9-1. Put down the canopy and check the all wires are connected properly.
From Remote
From House
(AC-N)
(AC-L)
White
Black
From Fan
Black
White
Black
White
Gray
Black
White
Gray
(
For motor
)
(
For motor
)
(
For motor
)
Green
( house ground wire )
Green
Green
( from Hanger Ball )
( from mounting bracket )
Blue
Blue
(
For Light Kit
)
Orange
Orange
(
For Light Kit
)
(
For motor
)
(
For motor
)
(
For motor
)
(
For Light Kit
)
(
For Light Kit
)
9-2. Process the resetting as following at 9-3.
9-3. RESETTING Process for receiver and transmitter:
9-4. Resetting for Muti-fans
