WARNING: blades should be at least 7 feet from floor
OFF OFF OFF
Turn off power at breaker
box to avoid possible
electrical shock.
Use metal outlet box suitable
for fan support.
Outlet box must support 35 lbs min.
Note 1:
Note 2:
1. HANGING SYSTEM INSTALLATION
1. Installing mounting bracket to ceiling outlet box
1-1. Install mounting bracket to outlet box on
ceiling by using screws included with the outlet
box and washers from the hardware bag.
1-1. Outlet Box
1-2. Screw (2)
(Loosening)
Mounting
Bracket
P3
Spring
Washer
Flat Washer
1-2. Loosen the screws at mounting
bracket.
Do not remove.
2. BLADE INSTALLATION
*Using Styrofoam as cushion for this step.
(From bag A.)
Blade Screw
& Spring Washer(2)
Blade(3)
Fan Assembly
L Type Hexagon Wrench
Blade(3)
(From bag B.)
Blade Screw(2)
Styrofoam
Styrofoam
Attach blades to fan assembly by using screws(2)
& spring washer(2) provided from hardware
bag marked
“A”
on top of fan assembly.
Attach screws(2) on bottom of fan assembly
provided from hardware bag marked
“B”
by using L
Type Hexagon Wrench provided from hardware bag.
(* Repeat until all 3 blades are installed firmly.)
*Note: Make sure all blade washers & screws are tightened to avoid operating noise.
*Place the fan assembly on Styrofoam with yoke up.
*Turning the
fan assembly
upside(Eclipse cap up).
Yoke
Yoke
Cap
Spacial Note: Top blade screw sets are using Bag “A” by phillips screw driver.
Bottom blade sets are using bag “B” by L Hexagon Wrench.
Fan Assembly
