6-1.Key hole
B
A
B
6-1.Key hole
A
A
B
A
B
Hanging
Bracket
Receiver
Canopy
6. CANOPY INSTALLATION
6-3.Key Hole (2)
6-3.Screw (2)
Canopy
6-5.Deco Ring
Note:
Two screws are installed on mounting
bracket for canopy installation.
6-1. Push canopy up until the two pre-screwed
screws on the mounting bracket are engaged
with the two key hole s on canopy.
6-2. Before rotating the canopy, make sure Key
hole
A
&
B
of the canopy correspond to
A
&
B
positions of the hanging bracket.
6-3. Rotate canopy slightly until the two pre-
installed screw heads are engaged in the narrow
end of key holes.
6-4.Tighten both screws.
6-5. Aligning the nubs from Deco Ring to 3 holes on
the canopy, push Deco Ring up and snap into the
canopy.
6-1.
6-1.
Dimming< >ON
12V
Dimming< >ON
7.TRANSMITTER
INSTRUCTION
Dimming< >ON
7
-
1
.
Install the battery
Remove the back cover and install the
12V battery. (Included from remote box)
7-2.Check the dip switch position
(Original dip switch is on Dimming position)
Set dip switch in
dimming
position for LED dimming.
Set dip switch in
On
position for LED ON/OFF only.
7
-
3. Install the back cover back.
12V
Turn on power at breaker box, the fan is ready for operation!
(The receiver will have beep sound)
OFF
OFF
OFF
ON
P6
