Connecting a Data Port
Tropos 5210 MetroMesh Router Installation Guide
40
Figure 25 Data Port Connection
6.
Connect the cable ends that were routed through the connector access cover to the LAN and
Management ports on the router. Use an appropriate RJ45 8-pin modular plug to terminate
the cables at the desired lengths. The outer jacket and conductive shield must be stripped to
expose the twisted pairs for attachment, as shown in
Figure 24
. The proper location of the
connections on the circuit board is shown in
Figure 26
.
7.
Verify that the protection unit is properly grounded.
trp_112
O-ring
AC power
connector
Cable guides
Ground bolt
Connector access cover
Tighten six screws to
fasten bulkhead plate
