2PS M3*10
screws
Z-Endstop
2PS M4*8
screws
Due to transportation reasons, the Z axis wire rod may not move smoothly or get stuck, the belt is
loose, and so on. The following steps can be used to fine-tune the product.
1. Z-axis screw debugging:
When the machine is not moving smoothly in the direction of the Z axis or is stuck, please loosen 2
M3 fixing screws of the motor components of the right and left Z axis or 4 M3*8 fixing screws of
the screw nut. Manually rotate the X-axis assembly to the highest point, then lock the 4 M3*8
screws in the screw nut. Also, manually turn the X axis component to the minimum, and then lock
the power unit 2 M3*8 screws (4 M3*8 screws of proper screw rod screws can be unscrewed if
there is any problem. The power will not be switched until the X-axis component is returned
smoothly.
X axis assembly
2. Belt adjustment:
If the belt is too loose or too tight, loosen the M4*8 screw slightly, and then drag it back or move
it forward. The elastic degree of the belt can be adjusted, and the screw can be locked after
being adjusted
2PS M4*8
screws
4PS M4*8
acrews
X- axis belt
Y- axis belt
6
、
Production debugging
