Page
4
of
9
3. Mode switching/Video recording/Photo shooting
After the camera is power-on, including the default mode, currently there are totally 4 modes can be switched
sequentially, please refer to the below table.
No.
Modes
Button pressing
LED status
Mode status
1
Video Mode 1 (default)
Default (without pressing)
Remains in green
Standby
Shutter button
Flashes in green
Recording
2
Video Mode 2
Mode button once
Remains in blue
Standby
Shutter button
Flashes in blue
Recording
3
Photo Mode
Mode button twice
Remains in red
Standby
Shutter button
Flashes one time
Shooting
4
Time-lapse photo mode
Mode button three times
Remains in red
Standby
Shutter button
Flashes in red
Shooting
Notes:
a. The default mode is video mode 1. User can change the parameter for all the 4 modes via software. The
available parameters of video mode 1 and mode 2 are the same (please refer to article 8 for configuration
method).
b. All the button-pressing times in the upper table are counted from the standby condition.
c. Each time user presses the button there will be a beep from the buzzer after user successfully presses the
operation button.
d. If the status indicator is not changed immediately, please don't press it again, the camera is saving data. Please
wait for a moment.
e. Under time-lapse mode, user only need to press the shutter button once, and then the camera will keep taking
photo in the equal intervals of time. To stop this mode, please press one time the
mode button
.
g. Under video modes, while taking videos, press the shutter button once to end video recording.
h. Under photo mode, after you press the shutter button, please keep the camera stable before the indicator LED
turns to “remains in red” for better picture quality.
4. Motion-detect video recording
The motion-detection function can only be switched on/off via the configuration software at present (please
refer to article 8 for configuration method). There is no extra button operation available.
4.1 Switch on the motion-detection in the software interface, and then Sync the configuration to the camera.
4.2 Turn on the camera then it will start to detect the motion. You don’t need to press the shutter button.
4.3 When the camera captures mobile objects within 3 meters, it will start to record a 1-minute-long video, and
then save the file automatically, standby for next motion.
4.4 Once the motion detection function is on, the camera won’t be automatically power-off even there is no
operation within 3 minutes.
4.5 To stop motion detection, please long press the power button, then the camera will be power-off.
4.6 The default video mode for this function is mode 1, you may also stop recording or switch it to video mode 2
manually.
Note: Better ambient brightness, better motion detection performance.
