10254 - 15
9. FREQUENTLY ASKED QUESTIONS – PURSUIT 330
1. The upright bike wobbles when in use.
• Turn the adjustable leveler on the rear stabiliser as needed to level the upright bike.
2. There is no display on the computer consol.
• Remove the computer consol and verify the wires that come from the computer consol are properly connected to
the wires that come from the handlebar post.
• Check if the batteries are correctly positioned and battery springs are in proper contact with batteries.
• The batteries in the computer consol may be dead. Change to new batteries.
3. There is no heart rate reading or heart rate reading is erratic / inconsistent.
•
Make sure that the wire connections for the hand pulse sensors are secure.
•
To ensure the pulse readout is more precise, please always hold on to the handlebar grip sensors with
two hands instead of just with one hand.
•
You are gripping the hand pulse sensors too tight. Try to maintain moderate pressure while holding onto the hand
pulse sensors.
Note
•
Avoid moving your hands while exercising and hold the hand pulse sensors firmly while exercising. If you do move your
hands while exercising, give the computer a few seconds to resample and display your correct heart pulse rate.
4. The upright bike makes a squeaking noise when in use.
• The bolts may be loose on the upright bike; please inspect the bolts and tighten the loose bolts.
5. Maintenance and cleaning.
•
Use a clean, damp, soft rag to clean the surface.
•
Use a mild detergent to clean the dirty spots.
•
Do not use a steel brush or abrasive cloth to clean the surface.
•
Immediately after exercise wipe off any sweat from the surface of the equipment. Perspiration contains salt which could
ruin the equipment.
