10254 - 11
5. COMPUTER FUNCTIONS (CONT. )
When the pre-set target calories count down to 0.0, calories will start to count up immediately
and the computer will begin beeping to remind you. (This data is a rough guide for comparison of
different exercise sessions and should not be used as medical advice).
ODO (ODOMETER): Displays the total accumulative distance traveled. The data values of the ODO can be cleared to
zero by pressing and holding the MODE or RESET button for 3 seconds. If you take the batteries
out of the computer, the ODO data values will clear to zero.
P (PULSE):
Displays your current heart rate figures after you grip the handlebar sensors with both your
hands during exercise. To ensure the pulse readout is more precise, please always hold onto the
handlebar grip sensors with two hands instead of just with one hand. You may also pre-set target
heart rate in the STOP mode before training. To set PULSE press the MODE button until you
see the P on the screen. Press the SET button, target heart rate will begin flashing. Press the SET
button to pre-set target heart rate. Press the RESET button to clear the target heart rate to zero.
The pre-set heart rate range is from 40 to 240 beats per minute. Once you pre-set target heart
rate and then start to exercise, please grip the handlebar sensors with both your hands during
exercise. If the heart rate detected is greater than the target heart rate, the computer will begin
beeping to notify you.
SPECIFICATION:
FUNCTION
Time
0:00-99:59 MIN: SEC
Speed
0.0-999.9 Unit: KPH
Distance
0.0-999.9 KM
Odometer
0.0-999.9 KM
Calorie
0.0-999.9 Kcal
Pulse
40-240 BPM
HOW TO INSTALL THE BATTERIES:
1. Remove the battery cover at the rear of the computer.
2. Place two “SIZE-AA” batteries into the battery housing.
3. Insure batteries are correctly positioned and battery springs make proper contact with the batteries.
4. Re-install the battery cover.
5. If the display is illegible or only partial segments appear, remove batteries and wait 15 seconds before reinstalling.
