INGROUND: SKIMMER ASSEMBLY
Countersunk Bolts (4)
Nuts (4)
Skimmer Mounting
Brackets (2)
Skimmer
2" Male Adapter
Skimmer
Support
Plastic Skimmer
Mounting Plate (1)
with gasket (1)
Install rubber gasket on the
mounting plate,
making sure the gasket straddles
both sides of the mounting plate.
(fig.H)
Slide skimmer face through
pre-cut skimmer opening,
keeping skimmer body on
outside of pool wall. Fasten
assembly by inserting 2”
countersunk bolts through
corner holes in mounting plate,
through pre-cut holes in pool
wall and through skimmer
mounting brackets, securing
with hex nuts. Tighten nuts to
a snug fit.
Do not over tighten as this will
damage the mounting plate.
Install skimmer support.
It is recommended that
2” PVC pipe be cut to size,
depending on installation. Utilizing
a 2” male adapter, attach support
to bottom of skimmer as shown.
Extension Collars
(fig.I)
are used
to raise the top of the skimmer to
the height of decking. The number
of extension collars needed is
determined by the variable decking height.
The skimmer faceplate is attached after the liner is installed.
Mounting Plate
Gasket
Tek screw
2" Wall Clip
Tek screw
Pool Interior
I.
H.
INGROUND: CP2 COPING INSTALL
Place pre-bent coping length on top of the pool wall. Se-
cure it with Tek screws at the previously installed 2” wall
clips. The next length is placed adjacent to the end of the
first length, continuing around the pool. It is not necessary
to leave spacing as with the standard white coping. If you
are installing a walk-in step, start at the step and continue
around the pool, cutting the last length to fit. Install coping
clips to cover the ends of the lengths.
15