AWC7813 motion controller user manual
WWW.SZTROCEN.COM
37
Table 3-7-2 Description of layer parameters
Name
Function Description
Work Mode
Set on the LaserCAD software, it can be divided into
【
Cut
】
,
【
Engrave
】
,
【
Punch
】
,
【
Pen
】
.
Speed
The working speed of processing of this layer. When the file is being
processed, the speed area of the main interface displays the speed
of the processing file. The maximum speed of actual work cannot
exceed the small value of
【
Max Speed
】
of
【
X, Y axis parameters
】
in
【
manufacturer parameters
】
. If the
【
Max Speed
】
of
【
X Axis
Parameters
】
is 600, and the
【
Max Speed
】
of
【
Y Axis Parameters
】
is 800, the layer speed is <=600. For related content, please refer
to
Power1
The former is the maximum power, and the latter is the minimum
power. When the file is being processed, the power area of the
main interface displays the power of the processing file. The
maximum power of the processing file cannot exceed the
【
MaxPower
】
in
【
Laser Parameters
】
, for related content, please
refer to
. Speed and power jointly determine
the depth of the cutting file and whether it can be cut through.
When the document cannot be cut through, increase the power
and slow down the speed; when the document is cut too deep,
reduce the power and increase the speed.
3.8 Count display area
In this area, you can check the number of file processing times, the former is
【
current counts
】
, and the latter is
【
cumulative counts
】
. In the
interface area division
interface, click the corresponding numeric key after
【
count
】
to
clear it. The panel can be counted in three modes:
【
Count per work
】
,
【
Count per
