Triumph Scrambler 1200 Steve McQueen Edition, Owner'S Handbook Manual

Page: 76 / 196

General Information
76
Tire Pressure Monitoring
System (TPMS) (if equipped)
Warning
The daily check of tire pressures
must not be excluded because of
the installation of the Tire Pressure
Monitoring System (TPMS).
Check the tire pressure when the
tires are cold using an accurate tire
pressure gage, see the Tire section for
more information.
Use of the TPMS system to set
inflation pressures may lead to
incorrect tire pressures leading to loss
of motorcycle control and an accident.
Tire pressure sensors are mounted
to the front and rear wheels. These
sensors measure the air pressure inside
the tire and transmit pressure data to
the instruments. The sensors will not
transmit data until the motorcycle
reaches a speed of approximately
12 mph (20 km/h). Two dashes will be
shown in the system display until the
tire pressure signal is received.
After bringing the motorcycle to a stop,
the sensors continue to transmit data
for approximately seven minutes before
switching off. The tire pressure values
remain shown in the system display
until the sensors switch off.
An adhesive label will be mounted to the
wheel rim to indicate the position of the
tire pressure sensor, which is near the
valve.
Note
The Tire Pressure Monitoring System
(TPMS) is available as an accessory kit.
It must be installed by your authorized
Triumph dealer.
The TPMS display on the instruments
will only be activated when the system
has been installed.
Tire Pressure Sensor Serial Number
The serial number for the tire pressure
sensor is printed on a label attached
to the sensor. This number may be
required by your authorized Triumph
dealer for service or diagnostics.
When the tire pressure monitoring
system is being installed to the
motorcycle, make sure that your
authorized Triumph dealer records the
serial numbers of the front and rear tire
pressure sensors in the spaces provided
below.
Front Tire Pressure Sensor
Rear Tire Pressure Sensor