9 of 20
25. Refit the relay block and cable grommet to the
battery tray moulding.
1. Relay
2. Grommet, wiring harness
26. Refit the diagnostic socket to the battery tray
moulding.
27.
Fit the twelve-way alarm connector to the new
7 mm hole drilled on the left hand side of the
battery tray moulding, as shown.
1. Battery tray moulding
2. Twelve-way alarm connector
3. 7 mm drilled hole
28. Refit the following components, as described in
the Service Manual:
• Battery
• Rear light (do not refit the rear rack at this
stage)
• Silencer.
29. Refit the tool kit.
30. Support the silencer and loosen its fixing. Raise
the silencer up and tighten its fixing to
15 Nm
.
1. Silencer mounting bracket fixing
2. Nut
31.
Remove the front four blanking plugs from the
underside of the rear subframe, as shown. Retain
the blanking plugs if the motorcycle is to be
returned to its original condition.
1. Subframe
2. Blanking plugs
Note:
•
Read the warning notices printed on the cleaning
wipe packet in the fitting kit.
2
1
2
1
3
1
2
CGON
2
1
4
