14 of 20
3.
Assemble a front pannier upper mount with a
pannier mounting plate and M8 x 80 mm bolt, in
the orientation shown below.
1. Front pannier upper mount
2. Pannier mounting plate
3. Bolt, M8 x 80 mm
4.
Fit the front pannier upper mount to the side
panel on the left hand side of the motorcycle, in
the orientation shown and retain with an M8 nut
from the kit. Tighten the nut to
20 Nm
.
1. Front pannier upper mount
2. Bolt, M8 x 80 mm
3. Nut, M8
5.
Repeat steps 3 and 4 for the rear pannier upper
mount.
6.
Repeat steps 2 to 5 for the right hand side of the
motorcycle.
7.
Refit the rear rack moulding and tighten the
fixings to
3 Nm
.
Pannier Cable Adjustment
1.
Check that the motorcycle is in an upright
position on a paddock stand or the centre stand
(if fitted).
2.
Mount the panniers as described on page
17
.
3.
From inside the battery tray moulding, slide the
rubber sleeve along the pannier cable to expose
the cable adjuster and lock nut.
1. Pannier cable
2. Rubber sleeve
3. Cable adjuster
4. Lock nut
4.
Loosen the pannier cable lock nut.
2
1
3
2
1
1
3
Warning
Cable adjustment must be carried out with the
panniers empty.
Adjustment of the pannier cable with the panniers
loaded will cause an incorrect adjustment to be set.
Riding the motorcycle with panniers fitted and the
cable incorrectly adjusted may cause the
motorcycle to become unstable leading to loss of
control and an accident.
4
2
1
3
4
