Triumph Adler LP 4118, Instructions Manual

Page: 6 / 50

Legal and Safety Information
iv OPERATION GUIDE
Interface connectors
IMPORTANT: Ensure the printer is powered off before connecting or
disconnecting an interface cable to the printer.
IMPORTANT: For protection against static discharge which may be
applied to the printer's internal electronics through the interface
connector(s), keep any interface connector which is not in use capped
using the protective cap supplied.
NOTE:
Use shielded interface cable.
Safety information
Laser safety
This printer is certified as a Class 1 laser product under the U.S.
Department of Health and Human Services (DHHS) Radiation
Performance Standard according to Radiation Control for Health and
Safety Act of 1968. This means that the printer does not produce
hazardous laser radiation. Since radiation emitted inside the printer is
completely confined within protective housings and external covers, the
laser beam cannot escape from the printer during any phase of user
operation.
Laser notice
This printer is certified in the U.S. to conform to the requirements of DHHS
21 CFR, Chapter I, Subchapter for Class I (1) laser products, and
elsewhere is certified as a Class I laser product conforming to the
requirements of IEC 825.
DANGER:
CLASS 3B INVISIBLE LASER RADIATION WHEN
OPEN. AVOID DIRECT EXPOSURE TO BEAM.
CAUTION:
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.