Triumph Adler DC 2118, Instruction Handbook Manual

Page: 81 / 108

Troubleshooting
7-6
Originals were set in the optional Document Processor
when copying on 2-sides (front and back sides), when
copying from the platen in 2-Sided copy, 2 in 1, 4 in 1 or
when collating copies. Remove the originals from the
Document Processor, replace the originals on the
Original Table after exiting the front and back copying,
2-Sided copy, 2 in 1, 4 in 1 or Collate Mode and resume
copying.
If the optional Document Processor is being used, there
are originals left on the original table. Remove the
originals, return them to the original table and try
copying them again.
Check the paper cassette that corresponds to the
lighting indicator. Set the cassette.
Tap and shake the new toner container without spilling
the toner, and install it again.
The Toner Container has not been set. Set the Toner
Container.
The Add Toner indicator blinks on
and off. There is very little toner remaining. Copying can be
continued for a short while before running out of toner.
Prepare the toner container.
The Periodic Maintenance
indicator blinks on and off. This is a notification that the time for periodic
maintenance is approaching.
The Periodic Maintenance
indicator lights up. It is time for Periodic Maintenance. Contact your service
representative.
“= = =” appears on the copy
quantity display. Job Accounting being set. Use the numeric keys to enter
the assigned Section Code to perform copying
operations. Press the
Logout
key after copying is
finished to display “= = =” again.
“-” appears on the copy quantity
display. The copier is in the Sleep Mode setting. Press the
Energy saver
key to exit the mode.
“---” appears on the copy quantity
display. The copier is in the Low Power mode setting. Press any
key to exit the mode or in the case where the optional
Document Processor is installed, set an original in the
Document Processor.
Display Corrective Procedure
Reseat originals
on DP.
Return all
originals to DP.
Set paper
cassette.
Shake the toner
container.
Set toner
container.