Installation procedure of drilling mechanism
1 Support rails installation for drilling mechanism
TIP: Rails are selfcentering. Rail centering is not necessary, since the holes are precision pre-
driller.
To make faster and easy to install drilling mechanism are all screws with inbus head 5mm.
Rails contain also predrilled holes M8.
All rails are designed to not cause any confusion to change by each other. This way you do
not use force for proper installation and therefore do not force or increased their strength in
the assembly. Therefore, these components made of lightweight aluminum profiles.
1.1 Dismantle by T handle 5 mm Allen key (# 12), two original screws on the left side of the
cylinder head (see detail red circles to indicate the location of the screws).
Picture
: Cylinder head of engine Fiat 3.0 diesel
1.2 Fit rail nr.1 on place of two removed scres. This rail is in its middle part specially shaped
to provide space for drilling out of broken stud on the first cylinder. C type of rail towards the
Picture 10.
Screw position, neccesary remove for installation rail nr.1
Picture 11.
Remove 2 screws using T handle allen key nr.14 and fittinng rail nr.1
