3.5 When base unit was installed, tight the 4 screws of base plate (Fig. 19). which hold the
longitudinal rails. Final centering carried out by setting of stop blocks (Fig. 20) on the sides,
to facilitate remove and insert drilling mechanism without resetting the base plate and
centered position.
3.6 Force the stop no. 1 to the middle part of a mechanism. Firmly tighten is needed.
Also, we force the stop No.2 to this mechanism and tighten it.
Note: After tightening all screws you have drill mechanism finally centered in alignment with
the broken stud M8.
